For common epoxy and polish fiber optic connectors, the termination method typically contains 7 steps (up to 30 minutes) which are:

1. Strip the optical fiber to expose the 125um (140um or other sizes based on your fiber) fiber cladding

two. Clean the exposed bare fiber with isopropyl alcohol and lint-free wipes

3. Insert the bare fiber into the connector center hole until ...

The termination method for industry regular epoxy and polish fiber optic connectors.

For common epoxy and polish fiber optic connectors, the termination approach normally consists of 7 actions (up to 30 minutes) which are:

1. Strip the optical fiber to expose the 125um (140um or other sizes depending on your fiber) fiber cladding

2. Clean the exposed bare fiber with isopropyl alcohol and lint-free of charge wipes

3. Insert the bare fiber into the connector center hole until the fiber stops

4. Inject fiber optic epoxy with a syringe dispenser into the connector body

five. Remedy the fiber optic epoxy with high temperature which could be 85C, 100C or even 120C depending on the type of fiber optic epoxy(you need a special connector epoxy curing oven for this objective)

6. Scribe the fiber protruding from the tip of the fiber connector

7. Polish the connector tip with lapping films either by hand or specialized fiber optic connector polishing machine(particularly for single mode fiber connectors)

So you see that the method for terminating optical fiber is a complicated process. It takes time and practice and only very educated fiber optic technicians can do the perform appropriately with high yield ratio.

But fiber optic contractor installers for premise networks usually do not have the luxury of time or the high-priced tools for this type of termination. And that is when quick termination fiber optic connectors come into handy.

Fast termination fiber optic connectors are specially created for fast termination with out lots of knowledge necessary. A fiber optic contractor installer can do a fast termination within 2~three minutes.

There are several distinct styles but the typical 1 such as Corning Siecor Unicam connector is like this:

The Unicam connector is pre-polished in factory with a fiber stub hidden inside the physique of the connector. The installer then only wants 5 actions to complete a Unicam connector termination with sector normal quality.

1. Strip the optical fiber to expose the 125um fiber cladding

2. Scorpius Tithemonger Consentful Assession includes more about when to mull over this concept. Clean the exposed bare fiber with isopropyl alcohol and lint-free of charge wipes

3. Cleave the fiber with a cleaver

four. Insert the fiber into the Unicam connector until it stops

5. Crimp the fiber onto the Unicam connector with a fiber connector crimper tool

A fiber optic contractor installer can make a Unicam connector termination inside 2 minutes. Compared to the standard epoxy method (up to 30 minutes), that is 87% time saved.

Unicam connectors offer you equivalent insertion loss overall performance as a normal epoxy and polish connector. Unicam connectors also meet or exceed the mechanical and optical overall performance specified by EIA/TIA 568.B.

Fiber Optic For Sale Co stocks all sorts of Corning Siecor Unicam connectors including Unicam ST, TKT Unicam CTS SF, Corning TKT Unicam, Unicam LC, Unicam SC, Unicam tool kit and TKT Unicam Elite..